Laying and handling guide

Fibre optic cables: laying and handling

Optical fibre cables, indoor and outside plant.

Every line names every source that states it and how it was seen; where sources disagree, each value is shown with its source. IEC, EN and HD documents and makers come first, national rules after them with their country.

Laying temperature and pre-warming

No value from a standard was found: use the maker's datasheet.

Bending radius

  • About 15 times the outer diameter under load and 10 times without (Corning ALTOS: 215 mm and 143 mm on 14.3 mm; OFS loose tube: a bend diameter of 30 and 20 times). A product value: check the datasheet.Sources: Corning, OFS (maker's document)

Pulling force and method

  • Armoured loose-tube cable of 12 to 72 fibres: 2700 N short-term (installation), 890 N long-term; industrial LSZH 48-fibre cable: 2700 N and 810 N. A product value: check the datasheet.Sources: Corning, OFS (maker's document)

Work out the pull for your route: the verdict is free, the numbers and the PDF come with Pro. Pull calculation in the cable designer · See Pro

Depth, cover and laying

Not found in the research for this family.

Drum handling

Not found in the research for this family.

Sheath test after laying

No sheath test after laying was found for this family.

In the cable designer

Cable codes of this family

Terms on this page

Sources

Values as the sources print them. For a given job the cable's own standard, the maker's datasheet and the country's rules decide.

Other cable families